CyberPower Network Management Card User Manual

Version 1.3User’s ManualPowerPanel Shutdown ServiceGraceful Shutdown and Notification service to ensure power protection of your computer

CyberPower Network Management System 8 [UPS Information] provides the technical specifications of your UPS. Information Descrip

CyberPower Network Management System 9 [Control] menu contains [UPS Control] page, [UPS Reboot] page, and [UPS Schedule] page. [UPS

CyberPower Network Management System 10 [UPS Reboot] allows advanced remote control of the UPS. Select one function by clicking its button. Cl

CyberPower Network Management System 11 [UPS Schedule]: Sets the UPS to automatically shutdown and restart at consistent times - weekly or daily.

CyberPower Network Management System 15 1. Input the receivers IP address. This address will identify the receiver of traps. The default value 0

CyberPower Network Management System 16 Information indicates an event that requires no action. Warning indicates an event that does

CyberPower Network Management System 17 [Summary] Displays the current UPS and CyberPower Network Management Card Status.

TABLE OF CONTENTS INTRODUCTION…………………………………...…………………1INSTALLATION GUIDE…………………………………...…………4CONFIGURATION GUIDE…………………

CyberPower Network Management System 18 Appendix 1 IP Address Settings of CyberPower Network Management Card Overview All devices on a computer

CyberPower Network Management System 19 If the response is shown as below, the IP address is in use. Try another IP address until an available addre

CyberPower Network Management System 1 INTRODUCTION Overview The CyberPower Network Management Card is an external card that allows remote monitori

CyberPower Network Management System 2 Unpacking Inspect the Network Management Card upon receipt. The package should contain the following: z C

CyberPower Network Management System 3 z Description 1) Serial Port provides a connection for communication between the UPS and the

CyberPower Network Management System 4 INSTALLATION GUIDE Step 1. Hardware Installation 1. Connect the Ethernet cable to the LAN port of the CyberP

CyberPower Network Management System 5 Figure 2. The SNMP card setting window. 6. First, choose either IP or MAC address from the d

CyberPower Network Management System 6 Figure 4. Setup IP Address successfully message. Method 2 : Use DOS Mode Setting 1. Obtain the MAC

CyberPower Network Management System 7 CONFIGURATION GUIDE [Monitoring] menu contains [Current Status] page and [UPS Information] page