CyberPower CPS1500AVR User Manual

User Manual for: CPS1500AVR UPSTM and PowerPanel Plus SoftwareADDITIONAL INSTALLATION TIPS CAN

6. Delay between warning messages - User adjustable setting for the delay between the audible alarms that occur during a power failure.7. UPS Self

5. Clear - Clears the selected item from the schedule.6. Add - Adds an item to the schedule.7. OK - Exits the window. Please note: You must click

FOR WINDOWS NT1. Click on Start, point to Settings, then click Control Panel.2. Double-click the UPS Icon.3. Remove the checkmark from the box l

TESTING YOUR UPS SYSTEMOnce you have set up your UPS system, you may wish to test it. Make sure that the UPS has been charged for at least 4 hours be

CAUTION! A battery can present a high risk of short circuit current an electrical shock. Take the following precautions before replacing the battery:

Power On Wiring AVR Using Circuit Alarm ConditionFault Battery BreakerOn Off Off Off Set Off NormalOn Off Flash Off Set Off AVR - Max. boost 15% of i

TROUBLESHOOTING14General Model CPS1500AVRCapacity 1500AV (950W)Input Frequency 47Hz - 63HzVoltage Range 85v - 150vUPS- Output Line Conditioning Regula

15Limited Warranty And Power Control GuaranteeIn purchasing a CPS1500AVR in the United States or Canada, the original end user receives a Limited Warr

POWER CONTROL GUARANTEEIf you are the Initial Purchaser and the Product is still covered by the Limited Warranty, the Power Control Guarantee provides

CONDITIONS COMMON TO THE LIMITEDWARRANTY AND THE POWER CONTROL GUARANTEEThe Limited Warranty and the Power Control Guarantee are the only and the excl

TABLE OF CONTENTSThank you for purchasing a Power Systems product. To enjoy all the features and benefits of this Uninterruptible Power System (UPS)

FCC Notice This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules. Th

CPS1500AVRGuaranteed Uninterruptible Power SystemDESCRIPTION1. Power Switch Can be used as a master on

2INSPECTIONThe box should contain the following:TM TM (1) PowerPanel Plus Software Disk;(1) PowerPanel Software Disk; (2) Serial Interface Cable (DB-

CPS1500AVRGuaranteed Uninterruptible Power System5. Plug the UPS into a 2 pole, 3 wire grounding receptac

TMPOWERPANEL PLUS SOFTWARE INSTALLATION GUIDE(Note: Use of the software is optional. The unit will provide surge suppression and batteryTMbackup wi

8. Windows will find new hardware.TM 9. Insert the PowerPanel Plus (Primary) disk into the floppy drive.10. Follow the on-screen instructions.11.

9. Connect the serial interface cable to the UPS and an open serial port on the back of the computer. You must use the serial cable that was

TMPOWERPANEL PLUS MAIN WINDOW DESCRIPTION1. Input Voltage - This reading shows the current input voltage of the utility power. The input normally d