CyberPower PowerPanel Power Supply System User Manual download pdf (Page 12)

PowerPanel

Business Edition

• *Restore power when the batteries have been charged to a

percentage of battery capacity: Sets how much battery capacity must be

present for the Battery Backup to restore power. 0% means the Battery

Backup will restore power immediately. Note: This setting is available only if

Wake up the Battery Backup when utility power is restored is enabled.

• *Output Frequency determination: Sets the frequency of output power

supplied to the connected equipment. You can choose only one of the

following settings.

o Following utility frequency when it is within a tolerance: Sets

the utility frequency thresholds. If the utility frequency is out of range,

the Battery Backup will supply power at a specific frequency.

o Fixed on a frequency: Sets the frequency of output power to a

constant value. This setting applies when the Battery Backup is in

standby mode. Standby mode occurs when the Battery Backup is

plugged into utility power and the Battery Backup is off.

Note: In general, you won't need to set this option in all cases. The wrong

frequency settings may damage your connected equipment. When you set

the frequency settings, you should ensure the selected frequency is

acceptable for your connected equipment. Each time you try to change

frequency settings, you will see an alert message and need to confirm the

change. These complicated steps are to protect your connected equipment

from the wrong frequency settings.

Battery

• *Prohibit batteries discharging over than 4 hours: If you enable this

option, the Battery Backup will shutdown when it has discharged for 4 hours.

Excessive discharging may shorten the life of batteries.

• *The Battery Backup will shutdown to save energy after a power

failure of 5 minutes: If you enable this option, the Battery Backup will

shutdown when a power failure occurs and the Battery Backup discharges

for 5 minutes without a load present. Otherwise, the Battery Backup will

keep discharging until battery capacity reaches 0%.

• *Battery is critically low when the capacity is below a percentage:

Sets the critical low threshold of Battery capacity. When the Battery

capacity is below this value, the Battery capacity is critical low event will

occur.

• *Perform a battery test: Set a schedule for recurring battery tests. The

battery test will verify the battery function supplies power when the Battery

Backup is in battery mode.

Configuration options: [never][every week][every 2 weeks][every 3

weeks][every 4 weeks]

• *The External Battery Cabinet has an amount of packs: Sets the

amount of external battery cabinet, it helps Battery Backup to evaluate

Remaining Runtime more accurate.

System

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Comments to this Manuals

No comments

CyberPower PowerPanel Power Supply System User Manual Page 12

Comments to this Manuals

Related products and manuals for Unknown CyberPower PowerPanel Power Supply System