CyberPower PowerPanel Power Supply System User Manual download pdf (Page 14)

PowerPanel

Business Edition

The runtime calibration synchronizes the runtime estimate with the current

load and battery capacity. When a runtime calibration initiates, Calibration is

initiated event occurs. A runtime calibration will discharge the batteries. The

batteries will be completely discharged after the calibration. The batteries will

be recharged automatically following a calibration.

Note: Frequent calibration will shorten the life of batteries. We recommend one

or two calibrations per year.

PERFORM A RUNTIME CALIBRATION

1. Click the Start button; this will initiate a runtime calibration.

2. Click the Stop button; this will stop the runtime calibration.

3. Runtime Calibration will display the result after a calibration finishes or you

stop the calibration. The results will report as follows:

• Estimated Runtime: The estimated runtime of the batteries.

• Last Calibration Result: The result of the last runtime calibration.

o Passed: Runtime calibration passed and the batteries are normal.

o None: A runtime calibration has not been run.

o Failed: The Battery Backup failed during the runtime calibration.

o Cancelled: The runtime calibration was stopped...

• Last Calibration Date: The date the last runtime calibration was performed.

Note: A calibration process causes the batteries to completely discharge. If a

utility power failure occurs during the calibration the Battery Backup will not

support the connected equipment.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

No comments

CyberPower PowerPanel Power Supply System User Manual Page 14