CyberPower PDU15M10AT User Manual download pdf (Page 24)

Appendix A-Hyper Terminal

Hyper Terminal software can be used for basic ATS PDU configuration. It utilizes a

text-based interface and menu system. Navigation through the interface is done

by typing the number of the menu option and pressing the Enter key.

Note: The session will timeout and logout after 3 minutes of inactivity. Menu

options are shown below:

[Main Menu]

1. Utility Configuration

2. Outlet Manager (Switched Series Only)

3. Load Configuration

4. Network Settings

5. System Configuration

6. Account Settings

7. Configure System to Default

8. Logout

[Utility Configuration]

1. Preferred Source: A

2. Sensitivity: High

3. Voltage Range: Medium

4. Frequency Deviation: 1 Hz

5. Nominal Voltage: 230 V

6. Wide Voltage Range: 30 V

7. Medium Voltage Range: 23 V

8. Narrow Voltage Range: 16 V

9. Set Load Restriction

[Outlet Manager]

1. Outlet Control

2. Outlet Configuration

[Load Configuration]

1. Device Threshold Configuration

2. Bank 1 Threshold Configuration

3. Bank 2 Threshold Configuration

4. Bank 3 Threshold Configuration

[Network Setting]

Physical MAC Address: 00-0C-15-00-00-01

1. System IP: 192.168.20.240

2. Subnet Mask: 255.255.255.0

3. Default Gateway: 192.168.20.254

4. DHCP: Enabled

5. Http Port: 80

6. Http Access: Enabled

[System Configuration]

1. Name: PDU15SW10ATNET

2. Location: Server Room

3. Contact: Administrator

[Account Setting]

1. Administrator

[Configure System to Default]

Sure to Configure System to Default

1. Reset ATS

2. Reset ATS (TCP/IP Settings Reserved)

1 2 ... 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

CyberPower PDU15M10AT User Manual Page 24

Comments to this Manuals

Related products and manuals for Power distribution units (PDUs) CyberPower PDU15M10AT