CyberPower PowerPanel Power Supply System User Manual download pdf (Page 9)

PowerPanel

Business Edition

The Power System Location page lets you configure the power system address

and view the connection state of Power System.

According to your Power System type, you may need to type Agent's address

or PMU's address in the Address field. When the address is configured, you will

see the connection state of Power System. Power System is the system

connected to the Battery Backup directly. The Power System Information

page is available only when the connection state is connected. Remember to

setup the same phase key in Security section as described on Protected

System Identification Help Page. If the phase key is different from Power

System and Slave, Slave will not have ability to communicate with Power

System.

POWER SYSTEM LOCATION

• Address: Displays the power system address. You can click Setup button to

configure the power system address. Normally, power system address is the

Agent or PMU address. You can link to Agent or PMU directly by click the

hyper link showed here. If the status is unreachable, it could be fail to open

due to wrong address.

• Status: Displays the status about the communication with Power System.

You can click Reconnect button to verify the current status about the

communication with Power System.

o connected: Slave is connected with Power System. Slave can obtain

information about Battery Backup from Power System.

o unreachable: Slave can't connect with Power System. It may due to

the wrong phase key, the wrong address, or the network connection

problem.

Note: After you configured the address, you need to wait for

negotiation for 5~20 seconds (depends on response time).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

No comments

CyberPower PowerPanel Power Supply System User Manual Page 9