CyberPower Remote Management System
3
INSTALLATION GUIDE
Step 1. Hardware Installation
Internal smart slot Remote Management Card
1. Turn off the UPS before removing the expansion port cover on the UPS.
2. Remove the two retaining screws from the expansion port cover and remove the cover.
3. Insert the CyberPower Remote Management Card into the expansion port.
4. Re-install and tighten the retaining screws.
5. Connect the Ethernet cable to the LAN port on the CyberPower Remote Management Card.
6. To connect with the environment sensor, use RJ45 Ethernet cable. Plug one end into the
Universal connector and the other end into the sensor (RMCARD203/303).
7. Turn on the UPS.
Comments to this Manuals