CyberPower PDU20SW8RNET User Manual download pdf (Page 16)

 Choose the component. If one single computer is connected to the UPS directly via a USB or serial connection,

Agent should be installed. If the computer is powered by a UPS already connected to an Agent, has a remote

management card installed or is connected to a PDU, Client should be installed. If the administrator requires

simultaneous monitoring and access to multiple UPS/PDU/ATSs, equipment and computers on a local network,

Center should be installed.

Note: Agent and Client cannot be installed on the same computer.

 Choose the destination location.

 Installation procedure starts to process until the installation is complete.

Installation on VMware ESXi and ESX

Installation on ESXi

Installation must be launched in the vMA (vSphere Management Assistant) which is also a virtual machine on the

ESXi host; Agent should be installed on the vMA of ESXi 4.1 or later versions. In order to deploy vMA on the ESXi

host and install PPBE in the vMA, users must install the vSphere Client tool on another remote computer first. To

download the vSphere Client installer, users can enter the ESXi host IP address to access the web page. Users can

visit VMware website for vSphere Management Assistant Guide document about vMA deployment on VMware

ESXi.

The installer will guide users in completing the installation. Refer to Installation on Text Mode section to follow the

same steps to complete installation. The installer requires root permission to initiate the installation procedure. Mount

CD by running mount –t iso9660 /dev/cdrom /mnt/cdrom as a root user.(/dev/cdrom is the CD drive and

/mnt/cdrom will be the mount point.). Browse the CD drive and find the installer in the /Software/Linux folder. Initiate

an installation procedure by running the ./ppbe-linux-x86_64.sh command.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 132 133

No comments

CyberPower PDU20SW8RNET User Manual Page 16