CyberPower PDU20SW8RNET User Manual download pdf (Page 94)

 Battery Replacement Date: The date that the batteries were last replaced. This should be set at the time of

battery replacement. If this date has not been set, it is recommended that this date should be set immediately.

 External Batteries: The amount of external battery packs connected to the UPS.

 Outlets: The amount of outlets on the PDU/ATS.

UPS

The UPS tab allows you to set up to connect the PDU with the monitored UPS in the Center. Select the Connect to

UPS option. Enter UPS IP address and assign the connected outlet. Click OK button to initiate a negotiation to

connect PDU with a UPS. When the PDU connects to the UPS successfully, this PDU connects to the assigned outlet.

All Clients which have communicated with this PDU will also establish the communication with UPS.

The UPS tab also allows you to set to connect the ATS with the UPS in Center. Select the Source A connect to UPS

(or Source B connect to UPS) option. Enter UPS IP address and assign the connected outlet for according input

source of ATS. Click OK button to initiate a negotiation to connect ATS with the UPS. When ATS connects to the UPS

successfully, all Clients which have communicated with ATS will also establish the communication with UPS.

Do not connect both sources to one single UPS. An ATS whose sources come from the same UPS cannot protect

connected computers and equipment from the power outage.

When one or more Clients are detected not to establish the communication with the UPS, the Center will show a

warning to inform users of this condition.

Energy

The Energy tab shows the chart how to spend the energy in a specified period and also shows the energy statistics of

the current target node and entire system.

Each UPS, PDU and ATS whose consumption will be logged per hour and each group which contains these

UPS/PDU/ATS will work accumulating the consumption of data. These data which logged the consumption in the past

can be gathered to render a chart in a past day, a past month, a past year and a past decade accordingly.

Administrators will realize how much energy has been spent in a past period. Energy can be spent more efficiently

and reduce the waste.

The Energy tab allows administrators to configure the proper thresholds to aware of violating consumption thresholds.

Once the power consumption violates thresholds, Center will warn administrators of the violation. The thresholds are

only applicable to current group or power equipment. When the thresholds are set blank, Center will use the

thresholds of the Default Energy in Energy Consumption/Settings page instead of thresholds in Energy tab.

Note: Internet explorer 6 and lower versions cannot support the graphic chart. The Internet explorer should be

upgraded to the higher version which is capable of rendering the graphic charts.

Device Operations

Center provides management functions for a UPS/PDU/ATS.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 132 133

No comments

CyberPower PDU20SW8RNET User Manual Page 94