CyberPower PDU20SW8RNET User Manual download pdf (Page 38)

UPS/Diagnostics page

Battery Test

The Battery Test performs a battery test to verify that the batteries are good, and shows information including the

result and the date of the last battery test. Click the Initiate button to begin a battery test. Performing a battery test is

prohibited when the Frequency Working Mode option is set to fixed.

The results will be reported after a battery test completes:

 Last Test Date: The date the last battery test was performed.

 Last Test Result: The result of the last battery test:

 Passed: The battery performed normally during the test.

 None: The UPS has never performed the battery test.

 Failed: The battery test resulted in failure.

Follow the below steps if the battery test fails:

 Repeat the battery test and replace the batteries if the test fails again.

 Contact CyberPower for assistance if the battery test fails after the batteries have been replaced.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 132 133

No comments

CyberPower PDU20SW8RNET User Manual Page 38