CyberPower PDU20SW8RNET User Manual download pdf (Page 76)

Network/Trap Notification page in the UPS RMCARD201 web

Note: SNMP community is limited to 15 characters in the PDU and UPS RMCARD.

Note: If you have firewall software installed, configure the settings to allow access through port 3052 (UDP/TCP), port

53568 (TCP), port 162 (UDP) and port 53566(UDP). The communication between the UPS RMCARD, PDU and

PowerPanel

Applications as Agent and Client can only be established when those ports are open.

SNMPv3

The Client uses the below SNMPv3 settings to interact with a secure device. These settings can be configured on the

Security/Authentication page in Client and on the Network Service/SNMPv3 Service page of the UPS

RMCARD/PDU/ATS web. These settings must be matched.

 User Name: Specifies a username match for protocol.

 Authentication Protocol: Sets the protocol to be used for authenticating the network communication between the

Client and devices.

 Authentication Key: Sets the authentication key which is used for the aforementioned authentication protocol.

 Privacy Protocol: Sets the privacy protocol to be used for encrypting data during transmission between the Client

and devices.

 Privacy Key: Sets the privacy key to encrypt data for the aforementioned privacy protocol.

Network

Data may be eavesdropped upon or falsified due to eavesdroppers or unknown network attacks when using the

PowerPanel

Business Edition. HTTP is insecure and subject to eavesdroppers or other network attacks which can

obtain the sensitive information such as website accounts or passwords. HTTPS provides secure identification and

encryption. HTTPS is usually used for sensitive transactions and PowerPanel

Business Edition also provides HTTPS

connections to access the web remotely.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 132 133

No comments

CyberPower PDU20SW8RNET User Manual Page 76