CyberPower PDU20SW8RNET User Manual download pdf (Page 30)

 Boost Charging: Boost charging involves a high current for a short period of time to charge the battery.

Boost charger enables the quick charging of depleted batteries.

 Float Charging: The float charger starts charging the battery by exerting a charging voltage. As the battery is

charged, its charging current reduces gradually. The float charger senses the reduction in charging current

and reduces the charging voltage.

 Exhausted: Batteries are exhausted; UPS stops the output power.

 Reversed Connection：Connection between UPS and batteries is wrong on electrical polarity.

 Capacity Critically Low: The battery capacity is too low and the UPS may shut down immediately.

 Not Present: There are no batteries present in the UPS.

 Testing: The UPS is performing a battery diagnostic test. See the UPS/Diagnostics page for more details

about the test results.

 Normal: The batteries are working normally.

 Voltage: The present voltage supplied by the batteries.

 Remaining Runtime: The amount of time that the UPS can supply power to its load.

 Remaining Charge Time: The remaining time the batteries required to be fully charged.

 Capacity: The present capacity of the batteries expressed as a percentage of full charge.

System

 Status: Displays the present operating status of the UPS.

 Normal: The operating status is normal.

 Fault: The UPS is in fault state due to an internal malfunction.

 Overheat: The temperature exceeds the normal temperature threshold.

 Bypass Fault: The bypass module of UPS has been malfunctioned.

 Bypass Fan Fault: The fan of the bypass module has been malfunctioned.

 Module Failure: One of UPS modules is no more normal and offline.

 Unable Recover: UPS fails to recover to line mode from bypass on occurred overload condition in past one

hour.

 Temperature: The present internal temperature of the UPS. It is displayed in both Celsius (°C) and Fahrenheit

(°F).

 Maintenance Break: Displays the present operating status of maintenance break.

Note: When the UPS needs maintenance or repair, the load can be transferred to maintenance bypass without

interruption and the power module can be removed for maintenance.

 Opened: The UPS is in maintenance bypass mode.

 Closed: The UPS is not in maintenance bypass mode.

 Module Status: Displays the present operating status of each UPS module.

 Normal: The module is operating normally.

 Offline: The module is not installed.

 Rectifier Fault: The module rectifier is faulty and stops output power.

 Inverter Fault: The module inverter is faulty and stops output power.

 Inverter Protected: The module inverter has been protected and stops operating.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 132 133

No comments

CyberPower PDU20SW8RNET User Manual Page 30