CyberPower PDU20SW8RNET User Manual download pdf (Page 41)

load’s plug from UPS to PDU, from PDU to UPS or between PDUs, assign the target UPS or PDU in the Device

option, and then click Apply to complete.

 Unplug the load from UPS or PDU. Click the target load you wish to unplug from the list. Click No on the

Enabled option and then click Apply to complete.

The PowerPanel Business Edition Client software can be installed on computers to benefit shutdown protection in

order to ensure a proper shutdown in the extended power outage event and control demands in UPS and extended

PDU.

Assigning a correct outlet is important. The Outlet option must be configured to match the actual equipment plugged

into the UPS outlet. Depending on the UPS configuration of specific models with NCL outlets, these outlets will lose

power before the entire UPS is shutdown. The Agent will request Client computers powered by these outlets to

perform a shutdown to avoid data loss because of the power outage.

Note: The Client computer name will be displayed in gray if communication with the Client computer is not established.

Manage PDU and ATS

When the PDU or ATS connects with the UPS as extensible outlets, users can manage these PDU/ATS in the list on

this page. A named PDU or ATS tab whose list contains connected generic equipment and computers will be created

due to the connection with PDU/ATS from UPS, and removed due to the disconnection with PDU/ATS from UPS.

 Install a PDU on UPS. Select the Install PDU from the dropdown menu by clicking the Power Distribution

shortcut on the list. If the PDU has network function, select Network from the PDU Type option, enter the network

address of PDU and assign the target outlet of UPS outlet that PDU had plugged in; if the PDU is generic PDU

without network function, select the Generic from the PDU Type option, select a PDU model from the Model option

and enter a name for the PDU. Click Apply to complete.

 Install an ATS on UPS. Select the Install ATS from the dropdown menu by clicking the Power Distribution

shortcut on the list. Assign the target UPS outlet that the ATS has plugged in, select the target input source of ATS

to connect with UPS and enter the network address of ATS. Click Apply to complete.

 Move PDU/ATS’s plug to another UPS outlet. Select the target PDU/ATS tab you want to move. Select

Configure PDU/ATS from the drop-down menu by clicking the Power Distribution shortcut on the list and select

another UPS outlet on UPS outlet option. Click Apply to complete.

 Uninstall the PDU/ATS from UPS. Select the target PDU/ATS tab you want to uninstall. Select Configure

PDU/ATS from the dropdown menu by clicking the Power Distribution shortcut on the list. Select Disconnect

PDU/ATS with UPS option and click Apply to complete.

Note: When a PDU/ATS is uninstalled from the UPS, all loads include generic equipment and computers on this

PDU/ATS will be removed; computers will also no longer keep communication with the UPS.

Note. PDU or ATS may be configured in the Power/Configuration page of PPBE Client’s web interface directly. A

named PDU/ATS tab with tip “Does PDU/ATS connect to UPS?” will appear automatically to inform you to ensure it.

Note. PPBE did not allow ATS to connect two input sources to one single UPS.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 132 133

No comments

CyberPower PDU20SW8RNET User Manual Page 41